Cigar Lighter Housing Replacement - Floor Console
CIGAR LIGHTER HOUSING REPLACEMENT - FLOOR CONSOLETOOLS REQUIRED
J 42059 Cigarette Lighter Socket Remover
REMOVAL PROCEDURE
1. Remove the lighter fuse.
2. Remove the lighter element.
3. Remove the lighter socket by placing one side of the T portion of J 42059 into the opening in the socket. Position the other side of the tool into the opposite opening. Pull the socket straight out.
4. If the standard method fails to remove the receptacle, use the following alternate method:
4.1. Insert a small grinding tool with a cutoff wheel into the receptacle.
4.2. Remove the plastic latches in the 3 mm (0.11 in) square windows.
4.3. Use J 42059 as directed above to remove the receptacle.
5. Remove J 42059 from the socket.
6. Disconnect the electrical connector from the socket.
7. Remove the retainer.
INSTALLATION PROCEDURE
1. Route the wiring harness through the retainer.
2. Install the retainer by pressing into place until fully seated.
3. Connect the electrical connector to the socket.
4. Align the socket to the to the retainer.
5. Press the socket into place until fully seated.
6. Install the lighter element.
7. Install the cigarette lighter fuse.
8. Inspect the lighter for proper operation.