Headlamp Switch: Service and Repair

HEADLAMP SWITCH REPLACEMENT

REMOVAL PROCEDURE




1. Pull the rearward edge of the access opening cover outboard on the left side of the instrument panel (I/P) to release the retainers. Use a plastic flat-bladed tool as an aid if necessary.
2. Release the forward edge of the access opening cover from behind the hinge pillar and remove the cover.
3. Remove the headlamp switch screws.




4. Carefully pull the headlamp switch outboard away from the I/P to access the electrical connector.
5. Disconnect the electrical connector from the headlamp switch.

INSTALLATION PROCEDURE




1. Connect the electrical connector to the headlamp switch.
2. Align the headlamp switch tabs to the I/P and press the switch into position.

NOTE: Refer to Fastener Notice in Service Precautions.




3. Install the headlamp switch screws.

Tighten
Tighten the screws to 1.8 N.m (16 lb in).

4. Align and insert the forward edge of the left I/P access opening cover behind the hinge pillar.
5. Align the access opening cover retainers to the slots on the I/P trim pad and press firmly to secure.