Brake Pressure Modulator Valve (BPMV) Bracket Replacement
Brake Pressure Modulator Valve (BPMV) Bracket ReplacementRemoval Procedure
1. Open the hood.
2. Remove the 2 Brake Pressure Modulator Valve (BPMV) bracket nuts (2).
3. Carefully position the (BPMV) out of the way.
4. Remove the 3 BPMV bracket to frame bolts (2).
5. Remove the BPMV bracket (1) from the frame (3).
Installation Procedure
1. Install the BPMV bracket (1) to the frame (3).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the 3 BPMV bracket to frame bolts (2).
Tighten the 3 bolts to 12 Nm (106 inch lbs.).
Important: Make sure that all 3 rubber isolators are installed on the BPMV. The isolators protect the EBCM/BPMV assembly from vehicle vibrations.
3. Install the EBCM/BPMV assembly (1) to the BPMV bracket (3).
4. Install the 2 BPMV bracket nuts (2).
Tighten the 2 nuts to 10 Nm (89 inch lbs.).
5. Close the hood.