Knock Sensor (KS) Replacement-Bank 2

KNOCK SENSOR (KS) REPLACEMENT - BANK 2

REMOVAL PROCEDURE
1. Turn the ignition OFF.
2. Disconnect the battery negative cable.
3. Raise and support the vehicle. Refer to Vehicle Lifting.




4. Remove the knock sensor (KS) electrical connector bracket bolt (2) located near the oil filter (3).
5. Remove the KS bolt (1).




6. Disconnect the KS electrical connector.

INSTALLATION PROCEDURE




1. Connect the KS electrical connector.




2. Install the KS and the knock sensor bolt.

Tighten the KS bolt to 23 N.m (17 lb ft).

3. Install the KS electrical connector bracket and the bracket bolt (2).

Tighten the KS electrical connector bracket bolt (2) to 65 N.m (48 lb ft).

4. Lower the vehicle.