Rear Door Window Motor: Service and Repair

Window Regulator Motor Replacement - Rear Door

Removal Procedure




1. Remove the door trim panel.
2. Peel the lower portion of the water deflector up in order to gain access to the window motor fasteners. Refer to Water Deflector Replacement - Rear Door.

Important: There is a binding effect on the power window motor drive when the window is in the fully closed or open position.

3. Partially open the window.
4. Disconnect the power window motor electrical connector.
5. Remove the 3 fasteners securing the power window motor to the window regulator.
6. Remove the power window motor.

Installation Procedure




1. Install the power window motor to the window regulator.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the power window motor to regulator fasteners.

Tighten the power window motor fasteners to 4 N.m (35 lb in).

3. Connect the power window motor electrical connector.
4. Inspect for proper operation of the window motor and a tight seal around the glass before installing the water deflector and the trim panel.
5. Install the water deflector.
6. Install the door trim panel.