Procedures

Opening the Endgate When There Is an Electrical Failure

Removal Procedure

1. Lower the endgate window out of the roof rear header seal.
2. Remove the endgate trim panel.
3. Remove the endgate inner reinforcement panel.




4. Locate the manual release lever (1), located on the upper and lower left latches (2).
5. Slide the manual release levers (1) upward to swing open the endgate.
6. Diagnose and repair the endgate latches.

Installation Procedure

1. Install the endgate inner reinforcement panel.
2. Install the endgate trim panel.
3. Check for proper operation of the endgate latches and window.