HVAC Control Module Programming and Setup

HVAC CONTROL MODULE PROGRAMMING AND SETUP

Each of the following service procedures may require programming or setup procedures to be performed on the HVAC control module or HVAC actuators.

HVAC Control Module Replacement
If the HVAC control module is replaced, an automatic re-calibration of all the actuators will occur. No additional procedures are necessary.

HVAC Control Module Reprogramming
Do not reprogram the HVAC control module, unless directed by a service procedure, or a service bulletin.

Reprogram HVAC Control Module-Refer to Service Programming System (SPS) .

Actuator Replacement
If an actuator is replaced, the following procedure must be performed:
- Re-Calibrating Actuators-Refer to Re-Calibrating Actuators (Primary) in HVAC Systems - Manual.
- Re-Calibrating Actuators-Refer to Re-Calibrating Actuators (Primary) Re-Calibrating Actuators (Auxiliary HVAC) in HVAC Systems - Automatic.