Window Track: Service and Repair

Window Run Channels Replacement - Endgate Lower

Removal Procedure

1. Swing open the endgate.
2. Remove the endgate trim panel.
3. Remove the inner reinforcement panel.
4. Remove the window.




5. Remove the screws retaining the run channels to the endgate.
6. Remove the run channels from the endgate.

Installation Procedure




1. Install the run channels to the endgate.
2. Loosely install the screws retaining the run channels to the endgate.
3. Install the window.
4. Lower the window down fully into the endgate.

Notice: Refer to Fastener Notice in Service Precautions.

5. Finish tightening the screws retaining the run channels to the endgate.

Tighten the run channel screws to 10 N.m (89 lb in).

6. Install the inner reinforcement panel.
7. Install the endgate trim panel.