Replacement

THEFT DETERRENT CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.

CAUTION: Refer to SIR Caution in Service Precautions.

2. Remove the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
3. Remove the lock cylinder. Refer to Ignition Lock Cylinder Replacement in Steering Wheel and Column.
4. Disconnect the connector from the theft deterrent control module.
5. If necessary, disconnect the connector from the ignition lock cylinder case (1).
6. Remove the theft deterrent control module (2) from the ignition lock cylinder case assembly (1).

INSTALLATION PROCEDURE




1. Install the theft deterrent control module (2) onto the ignition lock cylinder case assembly (1).
2. Connect the connector to the theft deterrent control module.

CAUTION: Refer to SIR Inflator Module Coil Caution in Service Precautions.

3. If necessary, connect the connector to the ignition lock cylinder case.
4. Install the lock cylinder. Refer to Ignition Lock Cylinder Replacement in Steering Wheel and Column.
5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement in Steering Wheel and Column.
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in Restraint Systems.
7. Program the theft deterrent control module.
8. Refer to Programming Theft Deterrent System Components. Programming and Relearning