103. Oil Pump Installation

Oil Pump Installation

Special Tools

J 45059 - Angle Meter

For equivalent regional tools, refer to Special Tools (Special Tools).




1. Install the oil pump drive spacer into the oil pump so that the drive flat engages the pump rotor.
2. Position the oil pump on the crankshaft.
3. Install the retaining bolts.

Caution: Refer to Fastener Caution (Fastener Caution).

4. Apply upward pressure on the pump while tightening the three retaining bolts. Tighten the bolts in the sequence (1, 2, 3) shown.

1. Tighten the oil pump mounting bolts in sequence to 10 Nm (89 lb in).
2. Tighten the oil pump mounting bolts in sequence an additional 35 degrees using the J 45059 - meter.