Operation CHARM: Car repair manuals for everyone.
Home >> Buick >> 2011 >> Regal L4-2.0L Turbo >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Service and Repair >> Removal and Replacement >> Engine Support Fixture
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Engine Support Fixture




Engine Support Fixture

Special Tools
* EN-28467-B - Universal Engine Support Fixture
* EN-43405-1 - Engine Support Feet (Passenger Side)
* EN-43405-2 - Engine Support Feet (Drivers Side)

For equivalent regional tools, refer to Special Tools (LDK, LHU) (Special Tools).

Installation Procedure

1. Remove the Intake manifold cover. Refer to Intake Manifold Cover Replacement (Intake Manifold Cover Replacement)
2. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement (Service and Repair).




3. Assemble the EN-28467-B - Universal Engine Support Fixture to the EN-43405-1 - Engine Support Feet (Passenger Side) and EN-43405-2 - Engine Support Feet (Drivers Side) and place across the engine compartment.




4. From the EN-28467-B - Universal
Engine Support Fixture universal engine support fixture, install the radiator shelf tube J-28467-2A (1) on top of the strut tower tube J-28467-3 (2) above the engine front (right back) lift hook bracket.
5. Install the round tube of the front support assembly J-28467-4A (3) through the large hole in the radiator shelf tube J-28467-2A.
6. Locate the J-28467-4A front support assembly to the upper tie bar.
7. Install the J-28467-9 7/16 inch x 2.0 inch quick-release pin (4) through the top hole in the J-28467-4A front support assembly.




8. Install the J-28467-1A cross bracket assembly (1).
9. Hand tighten the J-28467-1A cross bracket wing nuts (2).




10. Install the J-28467-7A bolt hook through the J-28467-6A bracket.
11. Install the J-28467-34 lift hook wing nut and washer to the J-28467-7A lift hook.
12. Repeat the previous 2 steps in order to assemble 2 lift hooks and brackets.




13. Install one of the lift hook and bracket assemblies (1) to the engine support fixture long bar (2).
14. Install the other lift hook and bracket assembly (3) to the J-28467-2A radiator shelf tube (4) above the engine front lift bracket.




15. Install the lift hook J-28467-7A through the engine rear lift bracket (2).




16. Install the lift hook J-28467-7A (3) through the engine front lift bracket (4).
17. Hand tighten the lift hook wing nuts J-28467-34 (5) in order to remove all slack from the engine support fixture assembly.

pro multis · About Operation CHARM