Do you have access to Mitchell1 Prodemand, or eautorepair.net DIY? If you are willing to share user/password (we can pay), please get in contact with us ASAP (truly, it is urgent): email operation-charm [[at]] tuta.io or click to submit anonymously
Cylinder Head Installation
Cylinder Head Installation (LAF, LEA, or LUK)
Special Tools
EN 45059 - Angle Meter
For equivalent regional tools, refer to Special Tools Tools and Equipment
Note:
Do not use any sealing material.
1. Install the cylinder head gasket to the block.
2. Install the cylinder head. Ensure the number 1 cylinder is at top dead center (TDC). The key on the crankshaft should be on top in the 12 o'clock position.
Caution:
Refer to Fastener Caution Fastener Caution.
Note:
Always use NEW cylinder head bolts.
3. Install the cylinder head bolts.
1. Tighten the bolts in sequence to 30 Nm (22 lb ft).
2. Tighten the bolts an additional 155 degrees in sequence using the EN 45059 - meter.
4. Install the front cylinder head bolts and tighten to 30 Nm (22 lb ft).