Lower Bearing & Steering Column Jacket - Standard

Jacket Replacement (Column Shift Standard)

Removal Procedure






Caution: Refer to SIR Caution in Cautions and Notices.

1. Disable the SIR system.
2. Remove the steering wheel from the column.
3. Remove the steering column from the vehicle.
4. Remove the ignition lock cylinder case.
5. Remove the turn signal and multifunction switch assembly.
6. Remove the linear shift assembly.
7. Inspect the steering column for accident damage.
8. Remove the adapter and bearing assembly (1) from the steering shaft assembly.





9. Remove the steering shaft assembly (1) from the steering column support assembly (2) and the steering column jacket assembly (3).





10. Remove the 4 TORX(R) head screws (1) from the steering column support assembly (2).
11. Discard the 4 TORX(R) head screws (1).
12. Remove the steering column support assembly (2) from the steering column jacket assembly (3).

Installation Procedure






Notice: Refer to Fastener Notice in Cautions and Notices.

1. Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 TORX(R) head screws (1).
^ Tighten the screws to 17 Nm (13 ft. lbs.).





2. Install the steering shaft assembly (1) into the steering column support assembly (2).





3. Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
4. Install the linear shift assembly.
5. Install the turn signal and multifunction switch assembly.
6. Install the ignition lock cylinder case.
7. Install the steering column into the vehicle.
8. Install the steering wheel onto the steering column.
9. Enable the SIR system.