Linear Shift

Linear Shift Assembly Replacement

Removal Procedure






Caution: Refer to SM Caution in Cautions and Notices.

1. Disable the SIR system.
2. Remove the shift lever.
3. Remove the upper and lower trim covers.
4. Disconnect the park lock cable assembly (1).
5. The steering column lock cylinder set should be in the OFF-LOCK position.
6. Insert a small screwdriver into the slot on the ignition lock cylinder case and push against the locking tab to remove.





7. Disconnect the automatic transmission shift lock control connector from the park position switch assembly.
8. Slide the park position switch assembly off of the linear shift assembly.






Notice: Do not use excessive force when removing the automatic transmission shift lock control from the steering column. Using excessive force may cause damage to the automatic transmission shift lock control and/or the steering column.

9. Remove the automatic transmission shift lock control from the steering column.
10. Use a small screwdriver to pry the automatic transmission shift lock control from the steering column jacket assembly.





11. Remove the 3 TORX(R) screws from the linear shift assembly.
12. Remove the linear shift assembly from the steering column support assembly.

Installation Procedure





1. Install the linear shift assembly onto the steering column support assembly.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Secure the linear shift assembly to the steering column assembly with the 3 flat head tapping screws.
Move the linear shift assembly out of the PARK position to install the lower socket tapping screw.
^ Tighten the 3 TORX(R) screws to 10 Nm (89 inch lbs.).





3. Install the automatic transmission shift lock control.
4. Install the shift lever clevis and put the column in the neutral position.
5. The neutral position is 2 positions from the park position.





6. Slide the park position switch assembly onto the linear shift assembly.
7. Connect the automatic transmission shift lock control connector onto the park position switch assembly.





8. Connect the park lock cable assembly (1) to the ignition lock cylinder case in the following way:
8.1. Place the steering column lock cylinder set into the off position.
8.2. Place the shift lever clevis into the park position.
8.3. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the ignition lock cylinder case.
9. Install the shift lever.
10. Install the upper and lower trim covers.
11. Enable the SIR system.