41. Rear Unit End Play Check (2)

^ Tools Required
- J 8001-3 Dial Indicator
- J 8520 Cam Lobe Lift Indicator Set





1. Assemble the J 8520 by attaching the threaded rod and the dial indicator holder to one of the case extension bolt holes on the transmission case (7).
2. Push the output shaft (671) in to take up any slack.
3. Mount the J 8001-3 on the J 8520 and index the J 8001-3 to the end of the output shaft (671).
4. Set the J 8001-3 to 0.
5. Move the output shaft (671) in and out noting the amount of end play.
^ The correct end play is 0.127-0.635 mm (0.005-0.025 inch).
^ If the end play is not correct, change the output shaft selective thrust washer (674). Refer to the Output Shaft Selective Thrust Washer Specifications table found in End Play Specifications.
6. Remove the tools from the transmission.