Switch Replacement - Door Lock and Side Window - Passenger
SWITCH REPLACEMENT - DOOR LOCK AND SIDE WINDOW - PASSENGERREMOVAL PROCEDURE
1. Remove the front door trim panel.
2. Remove the screw (2) that retains the switch panel bezel (1) to the front door trim panel.
3. Remove the switch panel bezel from the door panel using a flat-bladed tool.
4. Using a wide plastic flat-bladed tool, release the retaining clips on both sides of the door module.
5. Remove the door module from the switch panel bezel.
INSTALLATION PROCEDURE
1. Install the door module into the switch panel bezel until it snaps into place.
2. Install the switch panel bezel and module into the door trim panel.
3. Install the screw (2) that retains the switch panel bezel (1) to the front door trim panel.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten the screw (2) to 2 Nm (18 lb in).
4. Install the front door trim panel.
5. Perform the programming procedure for the Tire Pressure Monitoring system. Refer to Control Module Setup in Tire Pressure Monitoring.
6. Perform the programming procedure for the Keyless Entry system. Refer to Transmitter Programming in Keyless Entry.
7. If equipped with camper mirrors program the door module. Refer to Service Programming System (SPS). Service Programming System (SPS)