OnStar Call Center Remote Function Requests Malfunction

OnStar Call Center Remote Function Requests Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

Circuit/System Description

The communication interface module (CIM) has the capability of commanding the horn, initiating door lock/unlock, or operating the exterior lamps using the serial data circuits. These functions are commanded by the OnStar(R) Call Center per a customer request.

Diagnostic Aids

The customer concern may have been due to a lack of cellular service in a given area. A failure in the National Cellular Network infrastructure that has since been corrected.

Reference Information
Schematic Reference

OnStar Schematics OnStar Schematics
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

OnStar Description and Operation OnStar
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Scan Tool Reference

Control Module References Programming and Relearningfor scan tool information

Circuit/System Verification

Important: This procedure is not used in Brazil.


Important:
* It is necessary to inform the OnStar(R) Call Center advisor that this call is for vehicle diagnostic purposes.

* It is necessary to have the vehicle in an open outside area where a cellular call can be successfully placed and GPS data can be received from satellites.


1. Verify that the horn, lights, and the doors locks on the vehicle operate properly.

• If the applicable system does not operate properly, refer to Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle.

2. Contact the OnStar(R) Call Center by pressing the blue OnStar(R) button. Verify with the OnStar(R) advisor that all of the remote functions (door locks, lights, or horn) work.

• If unable to connect with the OnStar(R) call center, refer to Unable to Contact OnStar Call Center Unable to Contact OnStar Call Center.
• If the remote functions do not operate when requested, replace the CIM.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Programming and Relearningfor CIM replacement, setup, and programming