OnStar Voice Recognition Malfunction

OnStar Voice Recognition Malfunction

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions Diagnostic Procedure Instructionsprovides an overview of each diagnostic category.

Circuit/System Description

The CIM is capable of interpreting voice commands received over the cellular microphone circuits. Speech recognition allows the user to speak to one computer in the vehicle, and one reached over the cellular communication network. The module attempts to understand the users command, and responds by speaking back, or by taking the appropriate action, e.g. dialing the phone.

Reference Information
Schematic Reference

OnStar Schematics OnStar Schematics
Connector End View Reference

Component Connector End Views Connector End Views By Name
Description and Operation

OnStar Description and Operation OnStar
Electrical Information Reference

* Circuit Testing Circuit Testing
* Connector Repairs Connector Repairs
* Testing for Intermittent Conditions and Poor Connections Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs Wiring Repairs

Circuit/System Verification

Note: This procedure is not used in Brazil.

Note:
* It is necessary to have the vehicle in an open outside area where a cellular call can be successfully placed and GPS data can be received from satellites.
* The vehicle should be located in a quiet area.

1. Ignition ON, press OnStar(R) Call button. Verify that your voice is heard clearly by the OnStar(R) Call Center.

• If your voice can not be heard clearly, refer to OnStar Microphone Malfunction OnStar Microphone Malfunction.

2. Press the OnStar(R) Call answer button. Attempt to operate the OnStar(R) system using multiple different voice commands. Verify the system responds appropriately to all voice commands.

• If the OnStar(R) system does not respond to any voice commands, replace the CIM.

3. If the system is operational, but does not respond appropriately to certain commands refer to OnStar Description and Operation OnStar for tips on proper pronunciation.

Repair Instructions

Perform the Diagnostic Repair Verification Verification Tests after completing the diagnostic procedure.

Control Module References Programming and Relearningfor CIM replacement, setup, and programming