Fuel Filter: Service and Repair

Fuel Tank Fuel Pump Module Replacement

Special Tools

J 45722 Fuel Sender Lock Ring Wrench

Removal Procedure




1. Remove the fuel tank. Refer to Fuel Tank Replacement Removal and Replacement.
2. Disconnect fuel and evaporative emission (EVAP) lines from the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service Plastic Collar Quick Connect Fitting Service.

Caution: Avoid damaging the lock ring. Use only J-45722 to prevent damage to the lock ring.

Caution: Do Not handle the fuel sender assembly by the fuel pipes. The amount of leverage generated by handling the fuel pipes could damage the joints.

Note: Do NOT use impact tools. Significant force will be required to release the lock ring. The use of a hammer and screwdriver is not recommended. Secure the fuel tank in order to prevent fuel tank rotation.

3. Using the J 45722 and a long breaker bar, rotate the ring clockwise unlocking the fuel tank module lock ring.
4. Remove the lock ring.




5. Carefully lift the module from the fuel tank enough to access the quick connect fittings (1) under the module cover. Disconnect the quick connect fittings. Refer to Plastic Collar Quick Connect Fitting Service Plastic Collar Quick Connect Fitting Service.
6. Remove the fuel tank module.
7. Remove and discard the fuel tank module seal.





Note:
* Some lock rings were manufactured with "DO NOT REUSE" stamped into them. These lock rings may be reused if they are not damaged or warped.
* Inspect the lock ring for damage due to improper removal or installation procedures. If damage is found, install a NEW lock ring.
* Check the lock ring for flatness.

8. Place the lock ring on a flat surface. Measure the clearance between the lock ring and the flat surface using a feeler gauge at 7 points.
9. If warpage is less than 0.41 mm (0.016 in), the lock ring does not require replacement.
10. If warpage is greater than 0.41 mm (0.016 in), the lock ring must be replaced.

Installation Procedure




1. Install the NEW fuel tank module seal onto the fuel tank.
2. Pull the vent lines in the fuel tank up as far as possible for ease of installation.
3. Position the fuel tank module part way into the fuel tank.
4. Connect the quick connect fittings (1) to the module cover. Refer to Plastic Collar Quick Connect Fitting Service Plastic Collar Quick Connect Fitting Service.
5. Install the fuel tank module into the fuel tank.
6. Place the lock ring into position.





Note: Always replace the fuel module seal when installing the fuel module. Replace the lock ring if necessary. DO NOT apply any type of lubrication in the seal groove.

Ensure the lock ring is installed with the correct side facing upward. A correctly installed lock ring will only turn in a clockwise direction.

7. Rotate the lock ring counterclockwise using the J 45722 until fully seated.
8. Connect the fuel and EVAP lines to the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service Plastic Collar Quick Connect Fitting Service.
9. Install the fuel tank. Refer to Fuel Tank Replacement Removal and Replacement.