Door Lock Assembly

Lock Assembly and Door Ajar Switch:

Door Lock System Block-out Spring & Plug:

REMOVE OR DISCONNECT
1. All rods attached to lock.
2. Lock by straightening tabs.
3. Screw.
4. Door ajar switch by pushing down on switch to disengage lip on switch from lock.

INSTALL OR CONNECT

IMPORTANT
^ A new service lock will have a block-out plug installed. Do not operate lock or remove plug until lock is installed and rod is connected to lock.

1. Door ajar switch to lock by locating lip (4) on switch to lock and pushing up on switch.
2. Screw.
3. Lock by locating to door assembly and bending tabs over to secure lock.
4. All rods removed in step 1 of removal procedure.
5. Block-out plug.