Drive Axle - Wobble, Vibration Between 20-35 MPH
Bulletin No.: T-93-8File in Group: 4
Number: 2
Corp.Ref.No.: 214401
Date: Oct. 1992
SUBJECT:
DRIVE AXLE "WOBBLE" VIBRATION BETWEEN 20-35 MPH
MODELS AFFECTED:
1988-1992 DE VILLES, FLEETWOODS, ELDORADOS, AND SEVILLES
Some 1988-1991 DeVilles, Fleetwoods, Eldorados, and Sevilles and 1992 DeVilles, Fleetwoods, Eldorados, and Sevilles before the following VIN breakpoints may experience an intermittent vibration with a light engine load between 20-35 mph. This "wobble" condition is often described as a side-to-side motion of the front of the vehicle, similar to when a belt is damaged in a radial tire.
1992 DE VILLE, FLEETWOOD, ELDORADO, SEVILLE VIN BREAKPOINTS
This condition is caused by an intermittent binding condition of the S-plan inboard drive axle joints. This binding condition only occurs while the joint is rotating at vehicle speed with an engine load. The S-plan joint will not cause a vibration on a closed throttle coastdown.
This condition may be rgpaired by installing revised S-plan spiders and bearing blocks in both drive axles. The spider service kit, P/N 26039083, includes one spider, three bearing blocks, and two retaining clips. Two kits are required per vehicle. The revised spider incorporates ished surfaces and the bearing blocks have been enlarged. These changes went into production at the above breakpoints and will be incorporated in 1993 models as well.
Use the following service procedure:
1. Verify that the condition is not caused by tire imbalance. Refer to Section 3 of the appropriate Service Information Manual for tire balance diagnosis and repair.
2. Install two service spider kits (one per axle), P/N 26039083, following the service procedures in Section 4D of the appropriate Service Information Manual.
3. During joint disassembly, it is NOT necessary to remove the grease from the joint housing. The grease can be reused during reassembly with the new spider and bearing blocks.
Parts are currently available from GMSPO.
Warranty Information