Window Switch Trim Plate

WINDOW SWITCH TRIM PLATE

Front Door Power Window Switch:

REMOVE OR DISCONNECT
1. Use a 1/2 inch wide flat bladed tool to pry up on the rear edge of trim plate.
2. Insert the blade 3/4 inch into the door trim to engage retention clip. Press firmly toward switch plate to disengage clip.
3. Pull flat bladed tool upward while pressing firmly toward plate to pull plate from trim panel.

NOTICE: Before lifting switch plate from trim panel, insure that flat bladed tool has fully disengaged retention clip. Otherwise damage to switch plate or clip may occur.

4. Electrical connectors.
5. Switch plate.

INSTALL OR CONNECT
1. Electrical connectors.
2. Switch plate by setting plate into trim panel evenly and pressing into place to engage clips on both ends.