Holding Fixture Install

^ Tools Required
- J 39050 4T80-E Holding Fixture
- J 3289-20 Transmission Support Fixture Base





1. Install the J 39050 on the transmission.

CAUTION: To reduce the possibility of personal injury or transmission damage, make sure, when doing the next step, that all of the bolts for the support fixture are installed as shown, and that the bolts are tightened to 11 Nm (98 inch lbs.).

2. Install the holding fixture and the transmission into the J 3289-20.
3. Position the transmission with the case extension pointing downward in order to allow the fluid to drain.
4. Insert the pin into the base.