Installation Procedure

Installation Procedure
1. Install the pretensioner to the stud on the seat. Notice that the pretensioner has a tab that fits into the seat in order to insure that the pretensioner is in the proper position.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the nut to that fastens the pretensioner to the seat.

Tighten
Tighten the nut to 41 N.m (30 lb ft).

3. Carefully route the pretensioner pigtail harness under the seat.
4. Connect the pretensioner 2-way electrical connector to the 4-way side air bag connector.
5. Connect the side air bag/pretensioner yellow 6-way connector located under the seat.
6. Install the CPA to the side air bag/pretensioner yellow 6-way connector located under the seat.
7. Connect the 2-way seat belt switch electrical connector.
8. Install the pretensioner trim cover by engaging the rear, then pushing down on the front.
9. Install the driver seat.
10. Enable the SIR.