Garage Door Opener (GDO) - Programming

The system enters the learn mode when the two outside buttons are held down for more than 20 seconds. The rapid flashing of the red lamp confirms the system is in the learn mode. Release the buttons and bring the transmitting garage door opener within the learn mode operating range (3 cm maximum) once the system enters the learn mode. Press the button of the original transmitter to generate that transmitter's frequency. Decide which one of the three channels (buttons) you want to program. Hold down the desired channel (button) on the system control head until you see the red lamp on the control head flash rapidly while still holding the button of the original transmitter. Then, release both the buttons. The system learns and stores the garage door opener signal in a non-volatile memory within 90 seconds. The following actions take place upon being taught the Garage Door Opener (GDO) signal:
^ The system will accurately transmit the signal upon the next switch actuation.
^ The system will activate the applicable GDO receiver.