64. Converter Housing Selective Thrust Washer Check

- Tools Required
- J 23085-A Selective Washer Gauge





1. Install J23085-A on the adapter case flange and against the turbine shaft (506).
2. Loosen the thumb screw on J23085-A.
3. Position the inner shaft of J23085-A against the thrust service of the overrun clutch housing.
4. Tighten the thumb screw.
5. Remove J23085-A.





6. Measure gap 1. Compare the measurement of gap 1 to the selective washer table. The selective washer thickness must not exceed the measurement of gap 1. Refer to the Selective Thrust Washer table to compare the measurement of gap 1. The selective washer thickness must not exceed the measurement of gap 1. End Play should be between 0.1 to 0.8 mm (0.004 to 0.03 inch).
7. Select the proper thrust washer.