Bank 2

REMOVAL PROCEDURE

NOTE: Refer to Oxygen Sensor Notice in Service Precautions.

IMPORTANT:
^ Remove oxygen sensors with the engine temperature above 48°C (120°F). Otherwise the oxygen sensors may be difficult to remove.
^ A special anti-seize compound is used on the oxygen sensor threads. New service sensors should already have the compound applied to the threads. Coat the threads of a reused sensor with anti-seize compound P/N 5613695 or equivalent.

BANK 2 SENSOR 1

CAUTION: Refer to Vehicle Lifting Caution in Service Precautions.

1. Raise and support the vehicle.
2. Remove the front splash shield.
3. Disconnect the front oxygen sensor electrical connector.
4. Remove the front oxygen sensor from the front exhaust manifold.

INSTALLATION PROCEDURE

BANK 2 SENSOR 1

NOTE: Refer to Fastener Notice in Service Precautions.

1. Install the front oxygen sensor in the front exhaust manifold.

Tighten
Tighten the front HO2S sensor to 41 N.m (30 lb ft).

2. Connect the front oxygen sensor electrical connector.
3. Install the front splash shield.
4. Lower the vehicle.