Bracket Replacement - Night Vision Camera

REMOVAL PROCEDURE

IMPORTANT:
^ Do not remove the night vision bracket except for replacement.
^ If the night vision camera is removed or adjusted for any reason, it must be aimed. Refer to Night Vision Camera Aiming.




1. Disconnect the electrical connector.

IMPORTANT: Release the retainers from the back side




2. Turn the three camera retainers (1) 90 degrees and remove the camera from the mounting bracket.
3. Loosen the fasteners enough to remove the bracket from the hood latch bracket.




4. Push in and up on the mounting bracket to release it from the hood latch bracket.

INSTALLATION PROCEDURE




1. Install the night vision mounting bracket to the hood latch bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Lower the hood and tighten the night vision mounting fasteners through the grill. Ensure the camera aligns center with the grill opening.

Tighten
Tighten the night vision camera mounting fasteners to 9 N.m (80 lb in).

IMPORTANT: Make sure the retainers are fully turned and in the locked position.




3. Install the night vision camera to the mounting bracket and turn the retainers (1) 90 degrees from the back side.




4. Connect the electrical connector.
5. Perform aiming procedure for night vision camera. Refer to Night Vision Camera Aiming.