Instrument Panel (IP) - Insulator Panel Replacement - Left Side

Instrument Panel Insulator Panel Replacement - Left Side

Removal Procedure





1. Remove the fasteners (1) from the rear edge of the closeout / insulator panel (2).
2. Pull the closeout / insulator panel down in order to disengage the push pin type fasteners from the lower instrument panel.




3. Slide the closeout / insulator panel (2) toward the rear vehicle in order to clear the emergency brake bracket (1).



Installation Procedure





1. Slide the closeout insulator panel (2) over the top of the emergency brake bracket (1).




2. Set the forward edge of the closeout insulator panel (2) on the shelf above the carpeting.
3. Align the closeout insulator panel (2) with the fastener holes.
4. Install the push pin type retainers in order to hold the insulator panel in position.

Notice: Refer to Fastener Notice in Cautions and Notices.

5. Install the threaded fasteners (1) to the lower insulator panel.

Tighten the fasteners (1) to 2 N.m (18 lb in).