Electronic Column Lock Module - Assemble
Assembly Procedure- Tools Required
- J41396 Park Lock Cable Pliers
1. Install the lock bolt spring (3) into the steering column tilt head assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 3 o'clock position.
3. Install the lock bolt assembly (4) into the steering column tilt head assembly (5).
4. Push the lock bolt assembly (4) into the steering column tilt head assembly (5) until the lock bolt assembly is flush with the steering column tilt head assembly (5).
5. Align the lock module assembly (2) with the steering column tilt head assembly (5).
Notice: Refer to Fastener Notice in Service Precautions.
6. Screw the 3 pan head tapping screws (1) into the lock module assembly (2).
Tighten the pan head tapping screw to 7 Nm (62 inch lbs.).
Tighten the 2 pan head tapping screws to 2.3 Nm (20 inch lbs.).
7. Install the ignition and key alarm switch assembly and the coded key controller only. Refer to Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle (Power Tilt/Telescope-Column Shift) or Ignition and Key Alarm Switch Assembly -Assemble - Off Vehicle (Power Tilt and Telescope, Floor Shift) or Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle (Manual Tilt, Floor Shift) or Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle (Manual Tilt, Column Shift).
8. Install the steering column lock cylinder set only. Refer to Ignition Lock Cylinder Replacement - On Vehicle.
9. Place steering column lock cylinder set into the off position.
10. Place the shift lever clevis into the park position.
11. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the lock module assembly.
12. Adjust the park lock cable assembly (1) by performing the following steps:
12.1. Use the gear shift lever to place the steering column in the park position.
12.2. Insert the key into the ignition switch.
12.3. Place the steering column lock cylinder set in the off or lock position.
12.4. Remove the key from the ignition switch.
12.5. Unlock the adjuster ring on the park lock cable assembly using J41396.
12.6. Pull on the park lock cable until the park lock latch contacts the gear shift lever.
12.7. Release the park lock cable.
12.8. Lock the adjuster ring securely in place on the park lock cable assembly using J41396.
13. Inspect the park lock cable assembly by performing the following steps:
13.1. Insert the key into the ignition switch.
13.2. Place the steering column lock cylinder set in the off or lock position. The gear shift lever must remain locked in the park position.
13.3. Place the steering column lock cylinder set in the run position.
13.4. Place the gear shift lever in the neutral position.
13.5. With the gear shift lever in the neutral position, the steering column lock cylinder set must remain out of the off or lock position.
13.6. Place the gear shift lever in the park position.
13.7. Put the steering column lock cylinder set in the off or lock position.
13.8. Remove the key from the ignition switch.
14. Install the upper tilt head components. Refer to Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle (Power Tilt/Telescope - Column Shift) or Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle (Power Tilt and Telescope, Floor Shift) or Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle (Manual Tilt, Floor Shift) or Turn Signal Cancel Cam and Upper Bearing Inner Race - Assemble - Off Vehicle (Manual Tilt, Column Shift).