95. Accessory Installation

Installation Procedure





1. Place the drive belt tensioner in position. Be sure to locate the tensioner anchor pin in the cylinder head recess.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the drive belt tensioner bolt.
Tighten the drive belt tensioner bolt to 50 Nm (37 lb ft).

Drive Belt Idler Pulley

Installation Procedure





1. Place the drive belt idler pulley and bolt in position.

Notice: Refer to Fastener Notice in Service Precautions.

2. Tighten the drive belt idler pulley bolt.
Tighten the drive belt idler pulley bolt to 50 Nm (37 lb ft).

Generator

Installation Procedure





1. Install the torque strut mounting bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the torque strut mounting bracket bolts.
Tighten the torque strut bracket bolts to 50 Nm (37 lb ft).





3. Install the generator rear mounting bracket.
4. Install the generator rear mounting bracket bolts.
Tighten the generator rear mounting bracket bolt to 50 Nm (37 lb ft).





5. Place the generator in position.
6. Install the generator bolts finger tight.
7. Tighten the generator bolts in the following sequence:
7.1. Tighten the generator front lower bolt to 50 Nm (37 lb ft).
7.2. Tighten the generator front upper bolt to 50 Nm (37 lb ft).
7.3. Tighten the generator bracket bolts to the engine block to 50 Nm (37 lb ft).

Air Conditioning Compressor

Installation Procedure





1. Install the air conditioning compressor rear mounting bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the air conditioning compressor rear mounting bracket bolts.
Tighten the air conditioning compressor rear mounting bracket bolt to 25 Nm (18 lb ft).





3. Install the air conditioning compressor mounting stud.
Tighten the air conditioning compressor mounting stud to 25 Nm (18 lb ft).
4. Install the air conditioning compressor by sliding on the front mounting stud.
5. Install the air conditioning compressor rear mounting bracket bolt to the engine block finger tight.





6. Install the air conditioning compressor front mounting bolts and nut finger tight.
7. Tighten the air conditioning compressor mounting bolts and nut in the following sequence:
7.1. Tighten the air conditioning compressor front mounting nut to 50 Nm (37 lb ft).
7.2. Tighten the air conditioning compressor front lower mounting bolt to 50 Nm (37 lb ft).
7.3. Tighten the air conditioning compressor front upper mounting bolt to 50 Nm (37 lb ft).
7.4. Tighten the air conditioning compressor rear mounting bracket bolt to 25 Nm (18 lb ft).

Power Steering Pump

Installation Procedure

Important: You MUST push the power steering pump as far back toward the rear of the engine as possible before tightening the bolt.





1. Place the power steering pump in position in the engine valley. Slide the molded wedge into the retaining feature cast into the cylinder block.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the power steering pump bolt.
Tighten the power steering pump bolt to 50 Nm (37 lb ft).