Control Assembly: Service and Repair

REMOVAL PROCEDURE




1. Remove the radio.
2. Remove the HVAC control assembly.
3. Remove the nuts from the bracket that connects the radio and HVAC control assembly.

INSTALLATION PROCEDURE




1. Install the HVAC control assembly to the radio brackets.

NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the nuts.

Tighten
Tighten the nuts to 6 N.m (53 lb in.)

3. Install the radio.
4. Install the HVAC control assembly.