44. Assembly End Play Measurement

- Tools Required
- J 39686 Input End Play Check Tool
- J 8001 Dial Indicator Set





1. Install the J 39686 into the case barrel and install the post.





2. Locate the J tab on the input shaft (604). The arrow on the tab should have a 90 ° orientation.
3. The washer must rest flat on the case cover seal. Rotate the threaded shaft clockwise until tight. Leave enough space for the collar.
4. Insert the collar. Install the J 8001.





5. Push down on the handle and check the end play.
- The end play specification is 0.10-0.85 mm (0.004-0.033 inch).
If the measurement is out of the specification range, determine the appropriate selective thrust washer (522) for installation upon reassemble.

6. Remove the dial indicator and the post.