Window Adjustment - Door

REMOVAL PROCEDURE




1. Remove the trim panel.
2. Remove the speaker assembly.
^ Speaker Replacement - Front Lower (with UW6) or Speaker Replacement - Front Lower (with UQ4)
^ Speaker Replacement - Front Lower (with UW6) or Speaker Replacement - Front Lower (with UQ4)
3. Remove the water deflector.

PARALLELISM ADJUSTMENT PROCEDURE
1. Inspect the window parallelism adjustment. Perform the following steps:
1.1. Raise the window approximately 13 mm (0.5 in) below the full up position.
1.2. Inspect for parallelism on the upward motion of the window.
1.3. Ensure that the gap from the horizontal edge (1) of the window to the weather strip is even at the following locations:
^ The front of the window
^ The rear of the window




2. Perform the following steps to the inner cam bolts (2) in order to adjust the parallelism:
2.1. Loosen the bolts (1) on the door module (2).
2.2. Reposition the bolts (1).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Tighten the inner cam bolts.

Tighten
Tighten the inner panel cam bolts to 11 N.m (97 lb in).

WINDOW FORE AND AFT ADJUSTMENT PROCEDURE




1. Place the window in the up position.
2. Close the door.
3. Measure the space between the window and the B-pillar weather-strip retainer.

IMPORTANT: Moving the window too far will cause the following conditions to occur:
^ Increase the door closing effort.
^ Reduce the window seal contact at the B-pillar.
^ If the space is not within specification, perform the following procedures:

4. Ensure that the space is 6-7 mm (0.25 in).
4.1. Loosen the regulator to window sash channel (1) bolts.
4.2. Reposition the window.
4.3. Inspect the adjustment.

NOTE: Refer to Fastener Notice in Service Precautions.

5. Snug the sash channel bolts.

Tighten
Tighten the regulator to sash channel bolts to 11 N.m (97 lb in).