NVG 246-NP8 (Two Speed Automatic)

Removal Procedure





1. If the vehicle is equipped, remove the transfer case shields. Refer to Shield Replacement.
2. Remove the electrical connector from the speed sensor.
3. Remove the front speed sensor from the transfer case.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the front speed sensor into the transfer case.
Tighten the front speed sensor to 31 Nm (23 ft. lbs.).
2. Install the electrical connector to the speed sensor.
3. If removed, install the transfer case shields. Refer to Shield Replacement.