Turn Signal & Multifunction Switch - Assemble

1. Install the turn signal and multifunction switch assembly (3) onto the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the lower pan head tapping screw (2) first.
- Tighten the lower pan head tapping screw to 2.5 Nm (22 inch lbs.).
3. Install the top pan head tapping screw (1) last.
- Tighten the top pan head tapping screw to 2.5 Nm (22 inch lbs.).
4. Connect the 3 connectors to the turn signal and multifunction switch assembly (3).
5. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle