Parallelism Adjustment Procedure

1. Inspect the window parallelism adjustment. Perform the following steps:
1.1. Raise the window approximately 13 mm (0.5 in) below the full up position.
1.2. Inspect for parallelism on the upward motion of the window.
1.3. Ensure that the gap from the horizontal edge (1) of the window to the weather strip is even at the following locations:
- The front of the window
- The rear of the window




2. Perform the following steps to the inner cam bolts (2) in order to adjust the parallelism:
2.1. Loosen the bolts (1) on the door module (2).
2.2. Reposition the bolts (1).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Tighten the inner cam bolts.

Tighten
Tighten the inner panel cam bolts to 11 N.m (97 lb in).