Bracket Replacement - Night Vision Camera

REMOVAL PROCEDURE

IMPORTANT:
^ Do not remove the night vision bracket except for replacement.
^ If the night vision camera is removed or adjusted for any reason, it must be aimed. Refer to Night Vision Camera Aiming.




1. Disconnect the electrical connector.




2. Turn the three camera retainers (1) 90 degrees and remove the camera from the mounting bracket.




3. Remove the fasteners from the night vision camera bracket in order to remove the camera bracket from the hood latch bracket.

INSTALLATION PROCEDURE




1. Install the night vision mounting bracket to the hood latch bracket

NOTE: Refer to Fastener Notice in Service Precautions.

2. Lower the hood and tighten the night vision mounting fasteners through the grill, in order to ensure the camera is aligned with the center of the grill opening (1).

Tighten
Tighten the night vision camera mounting fasteners to 9 N.m (80 lb in).

IMPORTANT: Make sure the retainers are fully turned and in the locked position.




3. Install the night vision camera to the mounting bracket and turn the retainers (1) 90 degrees.




4. Connect the electrical connector.
5. Perform aiming procedure for night vision camera. Refer to Night Vision Camera Aiming.