Power Window Switch: Service and Repair

POWER WINDOW SWITCH REPLACEMENT - REAR DOOR

REMOVAL PROCEDURE




1. Insert a flat bladed tool under the rear edge of the rear door switch plate.

NOTE: The retainer clip must be fully disengaged before the switch plate is removed. Otherwise, damage to the switch plate could result.




2. Push the tool firmly towards the switch plate to disengage the retainer.




3. Lift up on the rear of the switch plate in order to remove the rear switch plate from the door trim panel.
4. Disconnect the electrical connector.
5. Remove the power window switch from the switch plate by disengaging the side snap walls with small flat bladed tool.

INSTALLATION PROCEDURE




1. Snap the power window switch into the switch plate.
2. Connect the electrical connectors.
3. Install the switch plate into the door trim panel.
4. Engage the front of the switch plate to the door panel.
5. Press down on the switch plate evenly to engage the retainer.