Zone 8

1. Remove the key from the ignition switch.




2. Connect the steering wheel module coil yellow connector (1) to the vehicle harness yellow connector (3).
3. Install the CPA to the steering wheel module coil yellow connector (1).
4. Install the driver/left sound insulator to the instrument Panel (I/P) (2).




5. Connect the driver/LF side impact module and seat belt pretensioner yellow connector to the vehicle harness yellow connector (1) located under the front of driver seat.
6. Install both CPA locks to the LF side impact module and pretensioner yellow connector (1).




7. Connect the left/driver roof rail module yellow connector (1) to the vehicle harness yellow connector (2).
8. Install the CPA (3) to the left roof rail module yellow connector (2).
9. Install the left rear sail panel.




10. Connect the passenger/I/P module yellow connector (1) to the vehicle harness yellow connector (2).
11. Install the CPA to the I/P module yellow connector (1).
12. Install the passenger/right sound insulator to the instrument Panel (I/P) (3).




13. Connect the passenger/RF side impact module and seat belt pretensioner yellow connector to the vehicle harness yellow connector (1) located under the front of passenger seat.
14. Install both CPA locks to the RF side impact module and pretensioner yellow connector (1).




15. Connect the passenger/right roof rail module yellow connector (3) to the vehicle harness yellow connector (2).
16. Install the CPA (1) to the right roof rail module yellow connector (2).
17. Install the right rear sail panel.




18. Install the SIR fuse into the right rear fuse center (1).
19. Install the right rear fuse center cover.
20. Install the rear seat.
21. Use caution while reaching in and turn the ignition switch to the ON position.
The AIR BAG indicator will flash then turn OFF.
22. Perform the Restraint Systems Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Restraint Systems.