Service Procedure

The following service procedure provides instructions for inspecting for a loose or missing intermediate steering shaft upper pinch bolt.

1. Turn the ignition switch to the ON position and turn the steering wheel so the front tires are straight ahead.

2. Turn the ignition switch to the OFF position.

3. Open the hood.





4. Inspect the intermediate steering shaft upper pinch bolt.

^ If the pinch bolt is present, turn the ignition switch to the ON position and turn the steering wheel 90 degrees (1/4 turn) to the left. Using a 13 mm socket, a long 3/8 drive extension, and a torque wrench, verify that the bolt is tightened to 30 N.m (22 lb ft).

^ If the pinch bolt is missing, turn the ignition switch to the ON position and turn the steering wheel 90 degrees (1/4 turn) to the left. Align the holes in the upper and lower shafts and install a new bolt. Using a 13 mm socket, a long 3/8 drive extension, and a torque wrench, tighten the bolt to 30 N.m (22 lb ft).

5. Install the GM Recall Identification Label and close the hood.