Vehicle Speed Sensor: Service and Repair

Vehicle Speed Sensor (VSS) Replacement

Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.





2. Disconnect the vehicle speed sensor (VSS) electrical connector (2).





3. Remove the VSS bolt (2).
4. Remove the VSS (1).
5. Remove the O-ring seal (3).

Installation Procedure





1. Install the O-ring seal (3) onto the VSS (1).
2. Coat the O-ring seal (3) with a thin film of transmission fluid.
3. Install the VSS (1).

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the VSS bolt (2).
- Tighten the bolt to 11 Nm (97 inch lbs.).





5. Connect the VSS electrical connector (2).
6. Lower the vehicle.
7. Refill the fluid as required.