Closeout/Insulator Panel Replacement - Right (LHD)

Closeout/Insulator Panel Replacement - Right (LHD)

Removal Procedure





1. Remove the fasteners (1) at the rear edges of the insulators in order to disengage the insulators from the lower instrument panel (IP).
2. Push in on the snap tab retainers in order to release the fasteners.




3. Disconnect the electrical connectors (1,2).
4. Slide the insulator (3) rearward toward the vehicle.



Installation Procedure





1. Set the forward edge of the insulator shelf on the carpeting at the front of the vehicle.
2. Connect the electrical connectors (1,2).




3. Align the insulator with the floor duct at the HVAC module.
4. Align the snap tab fasteners with the lower IP and push the insulator upward in order to engage the fasteners.

Notice: Refer to Fastener Notice.

5. Install the insulator fasteners (1) into the lower IP.

Tighten the fasteners to 2 N.m (18 lb in).