Drive Cable Replacement - Power Seat
DRIVE CABLE REPLACEMENT - POWER SEATREMOVAL PROCEDURE
1. Disable the SIR.
CAUTION: Refer to SIR CAUTION in Service Precautions.
2. Remove the seat bottom and frame assembly.
3. If the cable is equipped with a position sensor, remove the sensor retention clip and disconnect the electrical connector.
4. Squeeze the collar of the cable in order to release the cable.
5. Pull the cable out of the fitting until the cable end clears the fitting.
6. Remove the cable or cable/sensor assembly.
INSTALLATION PROCEDURE
1. Install the cable or cable/sensor assembly by pushing the ends into the fittings until the clip snaps into place.
2. If the cable is equipped with a position sensor, install the sensor retention clip and connect the electrical connector.
3. Install the seat bottom and frame assembly.
4. Enable the SIR.