115. Crankshaft Rear Oil Seal Installation

Crankshaft Rear Oil Seal Installation

^ Tools Required
- J 42842 Rear Crankshaft Oil Seal Installer





Important: Crankshaft rear oil seal and engine flywheel installation requires adequate space for installation. If the engine stand does not allow suitable space to use the J 42842 install the crankshaft rear oil seal and engine flywheel with the engine properly supported on the floor or on a bench.

1. Clean any debris from the crankshaft rear oil seal drain (1) using wire or an unbound plastic tie-wrap (2).

Important: Make sure the drain is clear before installing the new crankshaft rear oil seal. Failure to clear the drain could cause the crankshaft rear oil seal to leak.

2. Place a small amount of Gasket Maker, GM P/N US 1052942, Canada 10953466, or equivalent, at the crankcase split line across the end of the upper/lower crankcase seal.
3. Coat the outer diameter of the cylinder block crankshaft rear oil seal area with clean engine oil GM P/N US 12345501, Canada 992704, or equivalent.

Important: DO NOT allow any engine oil on the area where the crankshaft rear oil seal is to be pressed onto the crankshaft. The green coating pre-applied to the inner diameter of the crankshaft rear oil seal must not be contaminated.

4. Wipe the outer diameter of the flywheel flange clean with a lint-free cloth.





Important: DO NOT put any engine oil on the green coating pre-applied to the inner diameter of the crankshaft rear oil seal. This coating is a sealant that must not be contaminated.

5. Lubricate the outer rubber surface (1) of the crankshaft rear oil seal with clean engine oil GM P/N US 12345501, Canada 992704, or equivalent.

Important: It is not necessary to completely unthread the center bolt and separate the two pieces of the J 42842.

6. Loosen the center bolt of the J 42842 until the center hub protrudes approximately one-half inch beyond the outer plate.





7. Install the J 42842 to the rear of the crankshaft.





8. Thread the 3 mounting bolts into the crankshaft flange.
9. Tighten the 3 mounting bolts until the J 42842 is firmly mounted on the crankshaft.





10. Install the crankshaft rear oil seal by tightening the center bolt until the J 42842 bottoms against the crankcase.
11. Loosen the center bolt to release pressure on the crankcase.





12. Loosen the 3 mounting bolts.
13. Remove the J42842 from the crankshaft flange.
14. Inspect to ensure the installation depth is equal around the crankshaft rear oil seal's circumference. If the depth is not equal reinstall the J 42842 and repeat the installation procedures.