Connecting Rod, Engine
Connecting Rod BoltImportant: DO NOT reuse the old connecting rod bolts.
First Pass 30 Nm (22 ft. lbs.)
Second Pass Back off to zero
Third Pass 25 Nm (18 ft. lbs.)
Final Pass +110 degrees
Connecting Rod Bearing Material Aluminum
Production Clearance 0.025-0.076 mm 0.0010-0.0030 inch
Service - Maximum 0.076 mm 0.0030 inch
Connecting Rods
Diameter, Crankshaft End, Without Bearings 57.136-57.152 mm (2.2495-2.2501 inch)
Taper, Maximum 0.005 mm (0.0002 inch)
Piston Pin End, With Bushing (early design) 21.002-21.016 mm (0.8268-0.8274 inch)
Piston Pin End, With Bushing (late design) 23.002-23.014 mm (0.8268-0.8274 inch)
Taper, Maximum 0.007 mm (0.0003 inch)
Without Bushing 23.453-23.493 mm (0.9234-0.9421 inch)
Width 21.774 mm (0.8572 inch)
Center to Center 151.000 mm (5.9449 inch)
Side Clearance, Pair of Connecting Rods on Crankpin 0.200-0.500 mm (0.0079-0.0197 inch)