Removal and Replacement

Rear Side Door Window Regulator Motor Replacement

Removal Procedure





1. Remove the door trim panel. Refer toRear Side Door Trim Panel Replacement Service and Repair .
2. Remove the water deflector. Refer toRear Side Door Water Deflector Replacement (Service and Repair) .

Important: There is a binding effect on the power window motor drive when the window is in the fully closed or open position.


3. Partially open the window, if possible.
4. Remove the window regulator. Refer toRear Side Door Window Regulator Replacement Service and Repair




5. Remove the screws securing the power window motor to the window regulator.
6. Twist the power window motor clockwise to remove the motor from the regulator.



Installation Procedure





1. Install the power window motor to the window regulator.
2. Twist the power window motor counterclockwise to align the screw holes.

Notice: Refer toFastener Notice in Cautions and Notices.

3. Install the power window motor to regulator screws.

Tighten the power window motor screws to 4 Nm (35 lb in).





4. Install the window regulator. Refer toRear Side Door Window Regulator Replacement Service and Repair
5. Install the water deflector. Refer toRear Side Door Water Deflector Replacement (Service and Repair) .
6. Install the door trim panel. Refer toRear Side Door Trim Panel Replacement Service and Repair