Instrument Panel Module Replacement

Instrument Panel Inflatable Restraint Module Replacement

Removal Procedure

Caution: When performing service on or near the SIR components or the SIR wiring, the SIR system must be disabled. Refer to SIR Disabling and Enabling . Failure to observe the correct procedure could cause deployment of the SIR components, personal injury, or unnecessary SIR system repairs.

Caution: When carrying an undeployed inflator module:

- Do not carry the inflator module by the wires or connector.
- Make sure the air bag opening points away from you.

When storing an undeployed inflator module:

- Make sure the air bag opening points away from the surface on which the inflator module rests.
- Provide free space for the air bag to expand in case of an accidental deployment.
- When storing a steering column, do not rest the column with the air bag opening facing down and the column vertical. Lay the column on its side.

Failure to observe these guidelines may result in personal injury.

1. Disable the SIR system. Refer to SIR Disabling Service and Repair.






2. Remove upper I/P trim panel Service and Repair.
3. Remove the I/P inflator module connector from the I/P structure.
4. Remove the inflatable restraint I/P module nuts.
5. Remove the inflatable restraint I/P module.
6. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

Installation Procedure






1. Install the inflatable restraint I/P module to the I/P.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the nuts to the inflatable restraint I/P module.Install the top nuts first then the lower ones second.

Tighten
Tighten the nuts to 9 Nm (80 lb in).

3. Enable the SIR system. Refer to SIR Disabling Service and Repair.
4. Secure the inflator module connector to the I/P structure.
5. Install the upper I/P trim panel Service and Repair.