Windows: Adjustments

Window Adjustment - Door






Caution: Refer to Glass and Sheet Metal Handling Caution in Service Precautions.

Caution: Refer to Express Window Down Caution in Service Precautions.

1. Remove the door trim panel.
2. Pull down the upper portion of the water deflector far enough to access the window clamp nuts. Refer to Water Deflector Replacement - Front Door or Water Deflector Replacement - Rear Door.
3. Loosen the window regulator to window clamp nuts 4 revolutions.
4. Connect the door trim panel wire connector.

Important: Start the vehicle to ensure maximum power to the window motor. This is required in order to fully seat the window for adjustment.


5. Start the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

6. Using the power window switch, raise the window to the full up position.

Tighten the window clamp nuts to 11 Nm (98 lb in).

7. Inspect for proper window operation and a tight seal.
8. Shut off the vehicle.
9. Install the water deflector.
10. Install the door trim panel.