TV Antenna Amplifier Replacement (With RPO Code UE7)

TV ANTENNA AMPLIFIER REPLACEMENT (WITH RPO CODE UE7)

REMOVAL PROCEDURE
1. Remove the left and/or right sail panels.

IMPORTANT: There is a TV antenna amplifier on both the left and the right sides of the vehicle.




2. Disconnect the coaxial cable (4) and the electrical connection (3).
3. Remove the bolts (1) from the TV antenna amplifier (2).
4. Remove the TV antenna amplifier (2).

INSTALLATION PROCEDURE




1. Install the TV antenna amplifier module (2).Ensure that the alignment tab is located properly before tightening the bolts (1).
2. Install the bolts (1).

Tighten the bolts (1) to 9 N.m (80 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the coaxial cable (4) and the electrical connection (3).
4. Install the left and, or right sail panels.